3 Series E36 318is (M44) CONVER
41 62 014
Adjusting trunk lid to fit (4-door/2-
door/convertible)
Note:
Engine hood was fitted and screwed in an unfinished body
shell.
Unpainted surfaces become visible after subsequent
movement.
These surfaces must be touched up with paint in the body
color.
Press ejector into detent buffer and, in this position, twist slightly to
left with a Phillips screwdriver.
This locks the ejectors in the detent buffers.
Unscrew detent buffers from left and right sides of trunk lid.
Check fulcrum pads on lower section of trunk lid lock for damage
and replace if necessary.
RA Adjusting trunk lid to fit (4-door/2-door/convertible)
BMW AG - TIS
04.02.2013 03:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
