bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

5 RA Removing And Installing _ Replacing Right Bowden Cable (convertible Lid) > < 3 RA Removing And Installing _ Replacing Bowden Cable (actuation Reversal On Trunk Li|Page 2003
Page 1
background image

51 25 012

Removing and installing / replacing Bowden
cable (convertible top lid)

Open side windows.

Unlock soft top and raise over dead center.

Lift clamping bracket and soft top compartment cover upright.

Removing left convertible top lid lock,

refer to 51 25 033

Remove tab washers (1) and (2).

Squeeze together locking device and lift out Bowden cable.

Lift out cover on reversing mechanism.

Lift out retaining plate and disconnect Bowden cable. Squeeze
together locking device and lift out Bowden cable.

Installation:

Adjust Bowden cable to zero backlash.

Adjusting convertible top lid lock,

refer to 51 25 029

RA  Removing and installing / replacing Bowden cable (convertible top lid)

BMW AG - TIS

04.02.2013  03:44

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

5 RA Removing And Installing _ Replacing Right Bowden Cable (convertible Lid) > < 3 RA Removing And Installing _ Replacing Bowden Cable (actuation Reversal On Trunk Li|Page 2003