3 Series E36 318is (M44) COUPE
Installation
Installation of cylinder head is described separately from removal.
Assembly sequence for removal and installation is different.
Clean sealing faces of cylinder head and engine block; if
necessary, remove traces of sealing compound with hardwood
spatula. Ensure that no gasket debris drops into the oil and
coolant ducts.
Check that dowel sleeves are undamaged and correctly located.
Replace cylinder-head seal and rubber-profile seal.
Caution!
Use cylinder-head bolts once only.
Threaded bores in engine block must be free of dirt and oil.
Note:
Risk of cracking, incorrect tightening values.
Put the cylinder head on.
Install the new cylinder-head bolts (lightly oiled).
For torsion angle adjustment, use Special Tool 00 9 120 or
Special Tool 11 2 110.
RA Removing and installing cylinder head (M44)
BMW AG - TIS
05.02.2013 03:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
