3 Series E36 318is (M44) COUPE
If separate sheet-metal panels (1 and 2) are displaced on the
sheet-metal flange, shorten sheet-metal panel (2). The distance to
test surface (3) of special tool 41 5 031 may not be less than the
specified distance!
Note:
Use a sheet-metal cutter or slow-rotation angle grinder
(sparks) to shorten the sheet-metal flange.
Cover inside of car, door and neighbouring cars.
Touch up damaged paint finish after cutting the sheet-metal flange
to prevent corrosion.
Note:
Door seals are marked with a dot of paint at top close to B-
pillar.
Red = left door seal
Yellow = right door seal
Replace damaged door seals.
RA Aligning front doors
BMW AG - TIS
05.02.2013 12:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 14 -