3 Series E36 318is (M44) SAL
13 62 560
Removing and installing or replacing mass air
flow sensor (M44)
Switch off ignition.
Unfasten clips (1).
Turn and pull off multiple pin connector (2).
Unfasten hose clip (3).
Remove air-mass sensor.
Installation:
Interrogate fault memory of DME-control unit, check faults in
memory then cancel fault memory.
RA Removing and installing or replacing mass air flow sensor (M44)
BMW AG - TIS
06.02.2013 18:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
