3 Series E36 318is (M44) SAL
51 12 ...
Replacing side inlet for rear bumper as
service sector solution
Remove bumper,
refer to 51 12 000
Unclip center and side rubber guards and, if applicable,
remove heat shield,
refer to 51 12 005
Break welding and remove inlet.
Install new inlet with screws for plastic in provided holes.
Installation:
Length of screw similar to license plate holder screws:
approx. 13 mm
Installation:
Press plastic tabs wide with a soldering iron.
RA Replacing side inlet for rear bumper as service sector solution
BMW AG - TIS
07.02.2013 00:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -