3 Series E36 318tds (M41) SAL
11 44 000
Removing and installing/sealing or replacing
oil-water heat exchanger (M41)
Removing intake air manifold,
refer to 11 61 050
Drain and dispose of coolant.
Installation note:
Replace seal.
Tightening torque,
refer to Technical Data 11 11 5AZ
Bleeding cooling system and checking for water leaks,
refer to 17 00 039
Unfasten screw from main flow oil filter cover, lift screw and wait
until engine oil has drained out of oil-water heat exchanger and
back into oil pan.
Remove main flow oil filter cover.
Installation note:
Tightening torque,
refer to Technical Data 11 42 2AZ
Installation note:
Replace seals in main flow oil filter cover and on the screw.
RA Removing and installing/sealing or replacing oil-water heat exchanger (M41)
BMW AG - TIS
06.02.2013 20:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -