3 Series E36 318tds (M41) SAL
Support transmission with a workshop hoist.
Unfasten screws and remove cross member.
Installation:
Tightening torque, 23 71 1AZ / 2AZ.
Brace output flange with special tool 23 0 020 .
Release collar nut (1) with special tool 23 2 320 .
Installation:
Install collar nut (1) with screw retaining compound; for
compound,
refer to BMW Parts Service.
Tightening torque, 23 21 1AZ.
Detach output flange with special tool 33 1 150 from output
shaft.
Installation:
Heat output flange to approx. 80
°
C and push onto output
shaft.
Remove radial seal with special tool 00 5 010 .
RA Replacing radial seal for output flange (S5D 260Z/ 310Z)
BMW AG - TIS
06.02.2013 22:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
