3 Series E36 318tds (M41) SAL
Lift out circlip (1).
Note:
Select largest possible locating face on gear.
Press gear off the countershaft.
Bend 4 retaining lugs on locking ring (1).
Remove locking ring (1) from thrust washer (2).
Remove thrust washer (2) (two halves) and thrust washer (3) from
the countershaft.
Remove 4th gear (1), synchronizer ring (2) and needle bearing (3)
from the countershaft.
RA Dismantling and assembling all synchronizer units (S5D 200G/ E36 M41)
BMW AG - TIS
06.02.2013 22:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -