3 Series E36 318tds (M41) SAL
32 00 610
Adjusting toe-in and camber on front axle
Adjusting toe-in/toe angle difference:
Set steering gear to straight-ahead position (marking on case and
steering shaft must be aligned).
Clean thread on tie rod.
Slacken clamping nut, gripping tie rod end in the process.
Remove gaiter clamp.
Turn tie rod to adjust toe-in to specified value.
Tighten down clamping nut (2).
Tightening torque 32 21 5AZ
.
Install gaiter clamp.
RA Adjusting toe-in and camber on front axle
BMW AG - TIS
06.02.2013 23:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
