3 Series E36 318tds (M41) SAL
Fill new radial shaft seal between dust and sealing lip with grease,
refer to BMW Service Operating Fluids.
Drive radial shaft seal (16) firmly home in case section - open side
facing inwards - with special tool 32 1 140 /240.
Fit bracket (5) and case section (4) on shaft.
Clamp pulley flange in vise.
Install new O-rings (13 and 17).
Install pressure plate (15) with groove facing upwards and
cylindrical pins (10).
RA Dismantling and assembling vane pump (LuK/Vickers pump)
BMW AG - TIS
06.02.2013 23:49
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
