3 Series E36 318tds (M41) SAL
To determine the correct shim (X), the drive pinion is installed with
new taper roller bearings and no clamping bush.
Install drive pinion in the rear bearing outer race.
Draw front taper roller bearing onto drive pinion with special tool
23 1 300 in conjunction with a spacer bush.
Mount input flange.
By carefully tightening down the collar nut, adjust friction torque of
input taper roller bearing to 250 Ncm.
Caution!
When tightening down, keep checking friction torque with
special tool 00 2 000 at regular intervals.
RA Replacing bearing for drive pinion (Type K) - final drive removed -
BMW AG - TIS
07.02.2013 00:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
