3 Series E36 318tds (M41) SAL
Remove input flange with special tool 33 1 150.
The specified friction torque level is indicated for the new drive
pinion bearing,
refer to Technical Data.
The friction torque of the old bearings no longer needs to be
measured.
Press out drive pinion.
Extract front bearing outer race with special tool 33 1 350
(fixture).
(1) Spreader
(2) Front bearing outer race
(3) Puller bell housing
(4) Pressure bolt
Remove rear outer bearing race with special tool 33 1 351
/ 356 / 362 / 363.
Caution!
Shim (X) is located underneath the rear bearing outer race.
It will be needed again for pinion/crown wheel adjustments.
Caution!
Replace both drive pinion bearings, using only one make.
RA Replacing drive pinion with crown wheel (Type K) - final drive removed -
BMW AG - TIS
07.02.2013 00:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
