3 Series E36 318tds (M41) SAL
Install new limited slip differential with new bearings.
Use both bearings of same make. Note make.
Lubricate new bearings with approved final drive gear lube
thoroughly (refer to Fluids and Lubricants) and let them drip dry.
Install side bearing caps marked with belonging shims (1), but at
first without O-rings (2).
Tighten bolts of bearing cap opposite the crown wheel end
uniformly to correct tightening torque.
Tightening torque, refer to Technical Data
The compensating bore (1), recognized on the outside by tab (2),
always faces up in installed position of the transmission.
Axial preload force of differential case bearings (4000 N) can be
determined with help of the friction torque,
refer to Technical Data
Tighten bolts of second bearing cap uniformly only enough, that
the differential can still be turned easily.
RA Removing complete locking differential. (Type K) - final drive removed -
BMW AG - TIS
07.02.2013 00:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
