3 Series E36 318tds (M41) SAL
Connect bleeder hose with bottle to bleeder valve (accumulator).
Caution!
Pressure in accumulator will be approximately 120 bar.
Carefully open bleeder valve.
Start bleeding routine in selected menu item of special functions
(BMW Service Tester) and flush accumulator until escaping brake
fluid is free of air bubbles.
If necessary, repeat bleeding routine several times.
Close bleeder valve.
Install dust cap.
Install liner on inside of wheel house.
6. Remove bleeder
Check and, if necessary, correct brake-fluid level.
Screw cap on expansion tank (ensure that rubber seal (1) is
installed in cap).
RA Bleeding brake system with ABS/ASC+T
BMW AG - TIS
07.02.2013 00:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
