3 Series E36 318tds (M41) SAL
34 00 046
Bleeding braking system
Caution!
Note "General Data",
refer to 34 00 ...
Connect bleeder on expansion tank.
Note:
Check relevant Operating Instructions for each device.
Charging pressure should not exceed 2 bar.
Connect bleeder hose with bottle on rear-right bleeder screw.
Loosen bleeder screw.
Tighten bleeder screw when escaping brake fluid is free of air
bubbles.
Proceed in the same way at left rear, right front and left front.
After finishing work:
Check brake-fluid level.
Pay attention to rubber seal (1).
Refer to specifications on BMW Consumables (Group 34) for
approved brake fluid.
RA Bleeding braking system
BMW AG - TIS
07.02.2013 00:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
