3 Series E36 318tds (M41) SAL
Determine, mark and cut along cutting line on B-pillar at bottom.
Caution!
Do not cut through double panel.
Drill off welded spots in front and rear door opening.
Determine, mark and clean along cutting line at top of B-pillar.
Distance (A) = 610 mm
Caution!
Only cut through outer panel of B-pillar.
Grind off welding on hinges and retaining hook.
Note:
Shown as seen from inside of car.
Take off B-pillar outer panel.
RA Replacing left or right outer section on center door pillar (partial replacement
BMW AG - TIS
07.02.2013 02:01
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
