3 Series E36 318tds (M41) SAL
Version with external temperature display:
If necessary, remove external temperature sensor from left brake
air duct.
Version with heated spray nozzles (outside mirror heated):
If necessary, unclip temperature switch from right brake air duct.
Unfasten bolts in left/right wheel housing.
All except M3 with sequential M-transmission (SMG):
Pull bumper forwards to remove.
Only M3 with sequential M-transmission (SMG):
Pull bumper forward somewhat.
Unfasten bolts (1) and expanding rivet (2).
Pull water container off bumper and allow to hang on hoses.
Pull bumper forwards to remove.
Installation:
Make sure that there are no bends in the hose after
installation.
RA Removing and installing complete front bumper
BMW AG - TIS
07.02.2013 02:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
