3 Series E36 318tds (M41) SAL
Unfasten screw and remove drive disc with linkage.
Position drive disk with linkage on new flat motor. The drive disk
only fits onto the shaft in one position. The star in the drive disk is
flattened on one side. If the drive disk has a hexagon guide, this
guide must also be replaced. See further on in this document.
Pull out roller sun blind until the linkage on the left and right can
be suspended. Reinstall retaining clips.
Supply the flat motor with voltage and allow the roller sun blind to
extend and retract once completely. The extend the roller sun
blind again until the linkage has a clearance of approx. 10 to 15
cm.
RA Removing and installing or replacing drive for sun roller blind
BMW AG - TIS
07.02.2013 06:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
