3 Series E36 318ti (M44) COMP
Remove trailing arm,
refer to 33 32 000.
Coat bead of outer rubber mount with Circolight (refer to BMW
Parts Service).
Pull out rubber mount with special tool 33 3 051/052/053/054.
Note:
Installed position of rubber mounts.
Draw arm bush on press-in side according to illustration.
Coat eccentric rubber mount (1) with Circolight (refer to BMW
Parts Service) and position on trailing arm so that artificial line
matches up with marking on trailing arm bush. In so doing, note
whether toe-in increase or reduction is to be achieved, refer to
diagram below (read-off point).
Pull in rubber mount (1) with special tool 33 3 051/052/054/055.
Install trailing arm and carry out wheel alignment to check.
Diagram for toe-in correction, left wheel
RA Toe-in correction on rear axle (Compact, Z3)
BMW AG - TIS
07.02.2013 01:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -