3 Series E36 318ti (M44) COMP
Place special tool 41 5 035 (gage) on sill and door, and check
door alignment, correcting if necessary.
Contact surface (1) must be fitted completely.
Gap (2) must continue uniformly between test surface (3) and
door.
Note:
Gap (2) depends on the thickness of the PVC on the sill. On
repair sheet metal (sill without PVC coat) - gap (2) = 0 mm.
Caution!
Pay attention to the shape of the adjacent rear side panel
when checking and correcting.
Correcting:
Loosen nuts on hinge (2).
Correct the quantity and/or thickness of shims.
Tighten nuts.
Tightening Torque = 21 Nm
RA Aligning front doors
BMW AG - TIS
07.02.2013 03:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -