3 Series E36 320i (M50) CONVER
Unscrew screw. Remove pulse generator.
Installation note:
After assembly, make sure that the lead from the pulse sensor
does not contact the water pump drive gear.
M 50 VANOS (= Variable camshaft control unit):
Unscrew oil pipe from VANOS control unit.
Installation note:
Check sealing rings, replacing if necessary.
Unscrew bolts.
Remove earth tape (1) and suspension lug.
Unscrew screw. Remove pulse generator.
Installation note:
After assembly, make sure that the lead from the pulse sensor
does not contact the water pump drive gear.
RA Replacing impulse sensor on vibration damper (M50. M50 VANOS)
BMW AG - TIS
06.02.2013 22:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
