3 Series E36 320i (M50) CONVER
2.
Drill bore with determined drill bit and deburr, pilot-drill with a
smaller drill bit if necessary
3.
Clean component, eliminate paintwork damage if necessary
Important!
To avoid corrosion, stop chips/swarf by means of cavity
sealing.
Follow instructions on corrosion protection.
4.
Preserving cavity
Important!
Follow manufacturer's operating instructions.
Make sure straight shank rivet nut correctly contacts
component.
5.
Set straight shank rivet nut with hand rivet gun
Note:
According to the manufacturer, the pictured tool is suitable up to
an M8 thread (see Aftersales Assistance Portal (ASAP) -
Service/Technology - Workshop Equipment (Start BMW) -
Workshop Equipment Shop or www.bmwgroup-wep.com).
RA Installation solution for straight shank/hexagon rivet nut
BMW AG - TIS
07.02.2013 03:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -