3 Series E36 320i (M50) COUPE
Note:
If work was carried out on the camshafts previously, rotate
engine twice engine-wise, then check camshaft setting.
Secure crankshaft with special tool 11 2 300 in TDC position of
1st cylinder.
Caution!
Do not turn the engine back.
Remove special tool 11 2 300 before switching on the
engine.
Fit special tool 11 3 240 to camshafts.
The camshaft setting is correct if the special tool 11 3 240 can
be fitted to the cylinder head without a gap.
Remove special tool 11 3 240.
Unfasten and remove special tool 11 3 390.
RA Removing and installing or replacing VANOS adjustment unit (M50)
BMW AG - TIS
06.02.2013 22:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 11 -