3 Series E36 320i (M50) COUPE
Flange connection with compression spring
Loosen the flanged joint.
Separate exhaust.
Installation:
Replace screws and nuts.
The screw heads must be located on the side of the
compression spring.
Align the flanged joint.
Note:
Sealing taper is produced by upset pipe.
Installation:
Lubricate flanged joint lightly with copper paste CRC, refer to
BMW Parts Service.
Turn flanges until maximum possible ground clearance is
provided.
Align the flanges parallel to each another.
Align the exhaust system and insert the screws.
Caution!
Do not apply preload to compression springs on block.
Apply preload of measurement A to compression spring.
Tightening torque,
refer to Technical Data 18 00 4AZ
RA Removing and installing / replacing rear muffler (M40, M42, M43, M44, M50 B20, M
BMW AG - TIS
06.02.2013 23:42
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -