3 Series E36 320i (M52) CONVER
54 25 008
Adjusting both bowden cables for convertible
top lid locks
Note:
Removing left luggage compartment trim,
refer to 51 47 151
Remove tab washer (1) and disconnect convertible top lid drive
rod (2) from engine.
Note:
If this proves impossible, loosen nuts and slide back
convertible top cover motor until drive rod (2) can be removed
and installed without tension.
Insert household rubber hose through bore in convertible top
cover drive rod (2) and secure the ends with a welding wire in the
body aperture.
Open side windows, move clamping bracket into upright position.
Move convertible top lid into upright position by hand.
Note:
If drives are not unlocked, continue to actuate convertible top
actuator switch in direction "open" for approx. 3 seconds
(possible risk of damage to Bowden cables).
RA Adjusting both bowden cables for convertible top lid locks
BMW AG - TIS
07.02.2013 06:48
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -