3 Series E36 320i (M52) COUPE
Remove retainer (1).
Withdraw selector rod (3) from selector linkage joint and remove
shims (2).
Installation:
Apply thin coat of grease to selector rod.
Grease,
refer to BMW Service Operating Fluids.
Release nuts, remove clutch slave cylinder.
Pressure line remains connected.
Caution!
Relieve clutch slave cylinder slowly, as otherwise air will be
sucked in via the sealing sleeve.
Installation:
Tightening torque, 21 52 5AZ.
Pull wires off reverse-gear switch.
Detach oxygen-sensor plug from bracket.
Remove cross tube.
Roadster: Remove reinforcement bracket.
RA Removing and installing transmission (S5D 200G, S5D 250G)
BMW AG - TIS
07.02.2013 00:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -