3 Series E36 320i (M52) COUPE
Fit countershaft in a press. Press off 3rd gear (1), guide sleeve (2)
and bearing bush (3) from the countershaft.
Prior to assembly, check all synchronizing devices for wear.
For this purpose, determine gap measurement X between
synchronizer ring and the corresponding gears.
Measure near the detent lugs.
Uniformly press synchronizer ring in direction of taper.
Gap measurements of the individual gear wheels,
refer to Technical Data.
Connect needle bearing (1), 3rd gear wheel (3) and synchronizer
ring (2).
Note:
Coat needle bearing and synchronizer ring on bearing
surfaces with ATF-oil.
Heat guide sleeve to approx. 120
°
C (hot air blower) and position
on the layshaft. Position 3rd/4th gear guide sleeve and press on
with special tool 23 1 290 until secure.
Caution!
While pressing, ensure that the detent lugs (1) catch in the
opening in the guide sleeve.
RA Detaching and mounting all synchronizing devices S5D 200G/250G
BMW AG - TIS
07.02.2013 00:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -