3 Series E36 320i (M52) COUPE
34 10 014
Adjusting handbrake
Test specifications
-
When 1st tooth is engaged, no braking effect should
be applied at all.
-
The wheel circumferential force compared to the
wheel on the opposite side (measured on the roller
test rig) must not exceed the higher value by more
than 30
%
. Adjustment is necessary in case of greater
brake-force difference.
-
It should be possible to hold vehicle with handbrake.
-
Handbrake must be adjusted if handbrake-lever travel
is greater than ten teeth.
Note:
The handbrake can only be adjusted correctly if handbrake
cables and all moving parts of handbrake move easily and
function correctly.
Basic handbrake adjustment is necessary:
-
After replacing brake shoes
-
After replacing brake drums/brake disks
-
After resetting slack-control device
-
In case of excessive handbrake-lever travel (ten teeth)
Lift out dust cover.
Unscrew locknut using special tool 34 1 030 and loosen cable
completely.
Installation:
Lock adjusting nut with locknut.
RA Adjusting handbrake
BMW AG - TIS
07.02.2013 03:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -