3 Series E36 323i (M52) CONVER
Remove crown wheel (cold).
Installation:
Cold-press new taper roller bearing on using special tool
33 1 020.
Caution!
Always only use same make bearings for both.
Lift shaft seals out of both bearing caps.
Press outer bearing race out with special tool 33 1 350 / 351.
Caution!
Special tool must engage in the bearing outer race.
RA Replacing both bearings on final drive housing (Type M) - final drive removed -
BMW AG - TIS
08.02.2013 06:00
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -