3 Series E36 323i (M52) CONVER
Installation:
To determine the thickness of the correct shim (X), install
drive pinion with new tapered roller bearings, but without
bush.
Installation:
Install drive pinion in the rear bearing outer race.
Press-fit front taper roller bearing to the drive pinion with special
tool 23 1 300 in conjunction with a spacer bush but do not
tighten down.
Installation:
Mount input flange.
Gradually tighten collar nut, occasionally measuring friction torque
with special tool 00 2 000 (friction torque gauge) and adjust with
collar nut to 250 Ncm.
Block distance of drive pinion
Secure dial gauge in special tool 33 1 481.
Fit special tool 33 1 481 with dial gauge on special tool
33 1 482 and set dial gauge preload to zero.
RA Replacing drive pinion with crown wheel (Type K) - final drive removed -
BMW AG - TIS
08.02.2013 06:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -