3 Series E36 323i (M52) COUPE
32 00 150
Standard chassis / wheel alignment with DIN
load
Note:
•
Read and comply with General information and definitions.
•
Read and comply with General chassis definition.
•
If necessary, prepare lifting platform.
•
Drive vehicle onto lifting platform.
Note: The front and rear wheels must be positioned centrally
on the rotary and sliding plates.
•
Remove locking pins from both rotary and sliding plates, align
pickup using bubble level and activate
•
If necessary, switch on chassis alignment system
•
Move vehicle into design position
•
Enter customer and vehicle data
•
Identify chassis version and select vehicle
•
Enter tyre pressure and tread depth
•
Attach quick-clamping holder/quick-clamping unit to vehicle
and remove clamping levers in area of front wheels
•
Attach pickup to quick-clamping holder/quick-clamping unit,
align using bubble level and connect to rotary plates
Note: When using quick-clamping units, perform rim runout
compensation after installing the pickups.
RA Standard chassis / wheel alignment with DIN load
BMW AG - TIS
08.02.2013 07:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -