3 Series E36 325i (M50) CONVER
Installation:
Check cover seal, replacing if necessary.
Place outer and inner cover seals on cylinder head in advance.
Installation:
Check for correct seating of seal on back of cylinder head
when installing cylinder-head cover.
Installation:
Install and align cover.
Screw on cover nuts, but do not tighten them.
Tighten cover nuts diagonally from inside to outside.
For tightening torque, refer to Technical Data
RA Removing cylinder head cover (M50 VANOS)
BMW AG - TIS
08.02.2013 06:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
