3 Series E36 325i (M50) CONVER
Installation:
Apply Drei Bond 1209 sealing compound, see BMW Parts
Service, to the following areas:
-
A bead at the transitions to the cylinder head gasket on
the left and right.
-
Thinly and evenly to the entire sealing face of the timing
case cover to the cylinder head gasket.
Installation:
Install timing case cover, insert all screws and initially tighten
to approx. 5 Nm.
Installation:
Drive in dowel pins flush from front end.
Installation:
Fully tighten all screws in alternate sequence.
Tightening torque,
refer to Technical Data 11 14 1AZ.
Caution!
If all screws are tightened, they must be tightened again in a
second operation.
RA Removing and installing, sealing or replacing timing case cover at bottom (M50)
BMW AG - TIS
08.02.2013 06:46
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
