3 Series E36 325i (M50) CONVER
Take off protective cap.
Remove retainer (1) and shims (2).
Installation:
Check axial clearance, correcting if necessary, refer to
Technical Data
Check armature shaft, removing burrs if necessary.
Take off cover.
Insert a 22 mm wrench socket or piece of pipe (with an outside
diameter of approx. 30 mm) in order to prevent the carbon
brushes from springing out.
Installation:
Use wrench socket or pipe again to make installation easier.
Mount entire assembly on transmission case and then tighten
cable socket.
RA Disassembling and assembling starting motor/transmission gear
BMW AG - TIS
08.02.2013 07:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
