3 Series E36 325i (M50) CONVER
26 11 665
Replacing boot - constant-velocity joint
removed
Drive out cheese-head bolts using a plastic hammer.
Remove washers.
Pull or knock off end cover (1).
Watch out for seal (2) between constant-velocity joint and end
cover.
Check grease filling, adding grease if necessary,
refer to Technical Data.
Mount new end cover and boot on propeller shaft or on constant-
velocity joint.
Install washers and cheese-head bolts.
Drive in cheese-head bolts to fit tightly using a plastic hammer.
Pull boot onto propeller shaft.
Install hose clamp on boot and tighten.
RA Replacing boot - constant-velocity joint removed
BMW AG - TIS
08.02.2013 10:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
