3 Series E36 325i (M50) CONVER
31 35 005
Removing and installing or replacing push
rod (support) for stabilizer
Stabilizer connection on spring strut:
Remove nuts.
Installation note:
Use washer (2). Replace self-locking nut.
Key surface (1) on ball pin must be parallel to damper axis.
Tightening torque,
refer to Technical Data 31 35 7AZ
Unfasten nut and remove push rod.
Installation note:
Key surface (1) on ball pin must run parallel to damper axis.
Replace self-locking nut. Tightening torque,
refer to Technical Data 31 35 7AZ.
Stabilizer connection on control arm:
Unscrew nuts (1).
Installation note:
Replace self-locking nut (1). Fit washer (2).
Tightening torque,
refer to Technical Data 31 35 9AZ.
RA Removing and installing or replacing push rod (support) for stabilizer
BMW AG - TIS
08.02.2013 10:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
