3 Series E36 325i (M50) CONVER
Expose and drill out welding spots on connection point for door
section.
Expose and drill out welding spots on connection for side member
cover.
Remove side frame.
Expose internal connection point between wheel housing
extension and wheel housing and drill out spots.
Expose connection point between tail plate and trunk floor and drill
out spots.
Remove wheel housing extension.
Roughly separate wheel housing and remove.
Unfasten window guide below outside of wheel housing.
Expose connection points on inside of wheel housing (1), soft top
lid (2) and internal side member cover (3) and open welding spots
and welding seams.
RA Replacing rear left outer section of wheel housing (side panel removed)
BMW AG - TIS
08.02.2013 14:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
