3 Series E36 325i (M50) CONVER
54 31 030
Removing and installing / replacing
headlining in convertible top (with folding aid
for convertible top cover)
Removing and installing finisher for convertible top lock,
refer to 54 31 025
Remove adhesive tape at front (down one side).
Unfasten screws with special tool 54 3 160 and remove retaining
plates.
Installation:
Bores in retaining plates are off-center. The side with
dimension (A) is at lower front.
(A) = 12 mm
Unscrew bolts using special tool 54 3 160.
Remove tensioning cable (B3) and pull out through reversing lug
(U5).
Caution!
The screw lug (V2) must be resecured in the same position
immediately after unscrewing the tensioning cable (B3) (risk of
damaging convertible top cover).
Unscrew bolts using special tool 54 3 160.
Remove tensioning cable (B2) then secure spring (F1) once
again.
Note:
Note location of tensioning cable (B2) and mark where
appropriate.
RA Removing and installing / replacing headlining in convertible top (with folding
BMW AG - TIS
08.02.2013 17:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
