3 Series E36 325tds (M51) TOUR
Loosen nut until it contacts spring strut.
Installation:
Derust stub axle in area of contact face of rubber sleeve.
Tightening torque, 31 12 6AZ.
Unfasten screws.
Installation:
Clean tapped bores in steering knuckle. Always replace
micro-encapsulated bolts.
Tightening torque, 31 21 4AZ.
Release fitting screw.
Installation:
Use shim on both sides.
Replace self-locking nut.
Tightening torque, 31 21 4AZ.
Unscrew nut and pull off ball joint with special tool 31 2 160.
Installation:
Remove grease from bore and pin.
Replace self-locking nut.
RA Removing and installing left or right control arm
BMW AG - TIS
08.02.2013 22:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
