3 Series E36 328i (M52) TOUR
11 21 500
Replacing crankshaft (M52 / S52 / M52TU /
M54 / M56)
(engine removed)
Necessary preliminary tasks:
•
Removing cylinder head
•
Removing lower timing case cover
•
Removing all pistons
•
Remove end cover at rear; this operation is described in the
section Replacing crankshaft radial seal.
Checking axial clearance:
If permitted end float is exceeded, check crankshaft, guide
bearing shells and engine block, replacing if necessary,
end float.
Unfasten screw connection on reinforcement plates.
Note:
The reinforcement plates are not fitted on engines with gray cast
iron engine blocks or on engines with oil pumps integrated in oil
scrapers.
RA Replacing crankshaft (M52 / S52 / M52TU / M54 / M56)
BMW AG - TIS
09.02.2013 13:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
