3 Series E36 328i (M52) TOUR
Unfasten nuts and remove cable.
Installation:
Note line routing.
Tightening torque, refer to
Technical Data 12 41 4AZ
Unfasten screws from top and bottom of starter motor.
If installed:
Unfasten nut (1) on support and remove starter.
Installation:
Check starter pinion and starter crown gear for damage.
Dismantling and reassembling starter motor,
refer to Construction Group Repair Instructions
RA Removing and installing/replacing starter motor (M52, manual transmissions from
BMW AG - TIS
09.02.2013 14:23
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -