3 Series E36 328i (M52) TOUR
21 51 500
Removing and installing or replacing clutch
release bearing/lever
(transmission removed)
Detach release bearing (1).
Installation:
Clean all sliding surfaces on clutch release bearing, check for
damage and replace if necessary.
Do not grease clutch release lever.
Sliding surfaces (2) of clutch release bearing must rest on
sliding surfaces (3) of release lever.
Lightly grease sliding surfaces (2) of release bearing.
Grease, refer to BMW Service Operating Fluids.
Withdraw release lever (4) from spring wire clip (5) and remove.
Installation:
Clean release lever.
Lightly grease release lever at sliding surfaces (1 and 2) only.
Grease, refer to BMW Service Operating Fluids.
RA Removing and installing or replacing clutch release bearing/lever
BMW AG - TIS
09.02.2013 15:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
