3 Series E36 328i (M52) TOUR
Installation:
Check spring wire clip (5) and ball pin (6) for damage and
replace if necessary.
Lightly grease ball pin (6).
Grease, refer to BMW Service Operating Fluids.
Note:
The spring wire clip and ball pin must always be replaced on
the S6S 420G transmission.
Clean guide sleeve (7).
Important!
Do not grease guide sleeve.
If guide sleeve is greased, the release lever can stick on the
guide sleeve.
RA Removing and installing or replacing clutch release bearing/lever
BMW AG - TIS
09.02.2013 15:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -