3 Series E36 328i (M52) TOUR
Remove retainer (1).
Withdraw selector rod (3) from selector linkage joint and remove
shims (2).
Installation:
Apply thin coat of grease to selector rod.
Grease,
refer to BMW Service Operating Fluids.
Release nuts, remove clutch slave cylinder. Pressure line remains
connected.
Tightening torque, 21 52 5AZ.
Important!
Relieve clutch slave cylinder slowly, as otherwise air will be
sucked in via the sealing sleeve.
Pull wires off reverse-gear switch.
Detach oxygen-sensor plug from bracket.
Remove cross tube.
RA Removing and installing transmission (S5D 260Z, S5D 310Z)
BMW AG - TIS
09.02.2013 15:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
