3 Series E36 328i (M52) TOUR
Engine M50:
Version with Sheet Metal Flywheel (2):
Caution!
Keep to sequence of installation.
Sheet metal flywheel (2) has three indentations for the torque
converter mounting tabs.
When guiding the engine and transmission together the three
mounting tabs on the torque converter must be aligned with the
three indentations in the sheet metal flywheel. Non-conformance
leads to follow-up damage on the automatic transmission.
Turning on the torque converter, or engine, is no longer possible
after guiding the engine and transmission together and would lead
to damage.
Turn the torque converter on the transmission until bore (1) faces
down perpendicular to the tab.
Screw special tool 24 2 300 into the tab.
Bore (3) on drive plate must point perpendicularly to centre of
opening in oil sump.
Lift automatic transmission until bore (3) in drive plate is reached.
Guide transmission in carefully with special tool 24 2 300 in bore
(3) on the drive plate.
Bolt transmission housing to engine.
Unscrew special tool 24 2 300 from the tab towards the front.
Mount torque converter.
RA Removing and installing automatic transmission (A4S 270R/ 310R)
BMW AG - TIS
09.02.2013 15:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 9 -
