3 Series E36 328i (M52) TOUR
Instrument panel reinforcement, viewed from bottom side (cover
side).
Conversion instructions for this reinforcement, if necessary (refer
to list):
To convert instrument panel reinforcement, release screws (1)
and remove reinforcement.
Install this instrument panel reinforcement in new instrument panel
before installing latter.
Following conversion work must be carried out if
the previously fitted airbag cover was mounted to the instrument
panel and an airbag cover as of 05/98 is used as a replacement
with the transverse straps secured to the retaining rail:
-
Instrument panel is replaced,
airbag cover and airbag module are reused.
-Convert instrument panel reinforcement.
-
Instrument panel is replaced,
airbag cover and airbag module are replaced.
-No conversion work necessary.
-
Instrument panel is replaced,
airbag cover is replaced,
airbag module is reused.
-Convert reinforcement in instrument panel.
-Remove transverse straps (2) and retaining rail (1) from new
airbag cover.
-New airbag cover is held at instrument panel reinforcement.
RA Additional work with passenger airbag
BMW AG - TIS
09.02.2013 19:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
