3 Series E36 328i (M52) TOUR
Remove input flange with special tool 33 1 150.
The specified friction torque for the new input bevel gear bearing
is indicated,
refer to Technical Data
The friction torque of old bearings does not have to be measured.
Press out drive pinion.
Extract front bearing outer race with special tool 33 1 350
(fixture).
(1) Spreader
(2) Front bearing outer race
(3) Puller bell housing
(4) Pressure bolt
Extract rear outer bearing race with special tool 33 1 360
(fixture).
Puller consists of:
Special tool 33 1 351 (extractor head)
Special tool 33 1 362 (threaded spindle)
special tool 33 1 356 (support bridge)
Special tool 33 1 363 (pressure nut)
RA Replacing input bevel gear and crown wheel (Type M) - final drive housing remove
BMW AG - TIS
09.02.2013 19:25
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -