3 Series E36 328i (M52) TOUR
Unlock and pull off central connector.
Note:
Keep brake fluid out of cable connector.
Important!
Do not interchange (confuse) brake leads and mark where
appropriate.
Unfasten brake leads (1 ... 5) from hydraulic unit.
Installation:
Pipe connections
1.
front right
2.
front left
3.
Rear axle
4.
master brake cylinder V (front axle)
5.
master brake cylinder H (rear axle)
Tightening torque, refer to Technical Data 34 32 1AZ
Pull suction hoses off elbow on pump body and catch escaping
brake fluid.
Note:
Suction hoses were only fitted until 09/94.
Loosen retaining nut and lift hydraulic unit out of bracket.
RA Removing and installing/replacing ABS hydraulic control unit
BMW AG - TIS
09.02.2013 20:22
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
