3 Series E36 328i (M52) TOUR
35 41 000
Replacing accelerator pedal
Caution!
A removed accelerator pedal must always be replaced as
removing will damage the retaining clips. This would allow
the pedal to slide out of its holder and could cause an
accident!
Press off locking washer (1).
Disconnect pedal.
Installation:
Lubricate sliding surfaces with grease,
see Technical Data.
Press down on carpet, unbend retaining clips and lever out
accelerator pedal in upwards direction.
Installation:
Install accelerator pedal with pocket on holder on floor plate
and snap retaining clips into place.
Caution!
To be absolutely sure, check that retaining clips have
snapped into place.
RA Replacing accelerator pedal
BMW AG - TIS
09.02.2013 20:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -